
Chapter 4 Performing Cabling Tests
Performing Tone Generator Tests
LanScaperPRO Network Tester User’s Guide 49
Performing Tone Generator Tests
The Tone Generator test generates selectable tones for
use with tone tracers on either all pairs, a selected pair, or
a selected pin, depending on user selection. The signal
generated on a pair has the signal on one pin and the
complement of the signal on the other pin of the pair,
yielding a nominal 10 volts peak to peak across the pair.
To perform a tone generator test
1 Connect the cable to be traced to the tester.
2 Access the Cable Test Menu. (See “Accessing the
Cable Test Menu” on page 41.)
3 Scroll through the menu options using the arrow keys
until Tone Generator is highlighted.
4 Press the SEL key.
The pre-test Tone Generator screen appears. (See
Figure 22.)
Figure 22 The Tone Generator screen, pre-test
LanScaperPRO_User_Guide.book Page 49 Friday, January 25, 2008 1:14 PM
Komentáře k této Příručce