JDSU NT850 Uživatelská příručka Strana 82

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 106
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 81
Chapter 6 Interpreting Test Results
Status and Error Messages for Network Tests
66 LanScaperPRO Network Tester Users Guide
Status and Error Messages for Network Tests
DHCP Request
In the ping test with DHCP on, the LanScaperPRO
displays this message on the first status line while it is
trying to get the required information from a DHCP server.
The DHCP request is repeated every 10 seconds when a
response is not received, and the count is shown on the
same line as the status.
Find Active Link
The tester is searching for incoming link pulses while
waiting to start an active test. Hub Flash, Cisco Discovery,
and Ping test modes need to be connected to an active
network in order to run. In those modes, this status
appears while the tester is searching both the 1-2 and 3-
6 pairs for incoming Ethernet Link pulses.
Link Found
Status displayed while searching for link pulses after an
incoming signal has been detected.
Link Not Found
Status displayed while searching for link pulses and
nothing has been detected.
LanScaperPRO_User_Guide.book Page 66 Friday, January 25, 2008 1:14 PM
Zobrazit stránku 81
1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 105 106

Komentáře k této Příručce

Žádné komentáře